Mazak Integrex Feedrate Codes

[TSmcam]

Hi there,

I'm tuning a post for a customer, and I am trying to get clarification on the Mazak Integrex Feedrate Mode commands.

G94 - Feed in mm/min (or in/min)
G95 - Feed in mm/rev (or in/rev)

Is this both for milling and turning?

If so, is G98/G99 as per mills, and return plane for drilling?

Or, is G98/G99 feedrate mode switching for milling?

Any help would be greatly appreciated

Cheers,

Mick

[JParis]

Straight out of an i100 BARTAC Manual

13-4 Initial Point and R-Point Level Return: G98 and G99 .....................................13-43

[TSmcam]

Sweet. Thanks John. So for both milling, and turning, the feedrate mode is G95/G94?

[dcolin]

I guess it can be set differently. On my machines (Integrex 200-III 640MtPro / Integrex 200-IV Matrix), it's G98/G99 both in lathe/milling modes.