MultiXpost interpolate error

[JParis]

Wasn't there a setting that could make this issue go away...seems to me there is but I am having a complete brain fart

[JParis]

Found it...

Needed to set this..

Change "From Vector" to by Axis values(non-RCTP)

[Jeff]

Found it...

Needed to set this..

Change "From Vector" to by Axis values(non-RCTP)

I'll have to try that next time. I've always just UNchecked the Max Distance in the Resulted RAPID moves right below that dropdown to get rid of that stupid error.

[Jeff]

On a side note, is there a way to change the default settings on that Sim page? The Module Works page, not the Mastercam Sim page.