Use Vericut For 3-Axis Machines?

[Brian]

OK! I figured there must be something like this in MC, too.

[neurosis]

OK! I figured there must be something like this in MC, too.

I think I've tried that utility in the past and I don't remember it working very well. I completely forgot that it existed. From what I remember, it's nowhere near as nice as whats in TS but I'll save that opinion until I try it out on Monday.   

[TSmcam]

I think I've tried that utility in the past and I don't remember it working very well. I completely forgot that it existed. From what I remember, it's nowhere near as nice as whats in TS but I'll save that opinion until I try it out on Monday.   

Of course it wont be as nice TS... LOL

[neurosis]

OK! I figured there must be something like this in MC, too.

I set up a quick little roughing routine and it seemed to work. It's definitely not as nice as what's in TS but in this case at least, it gave what looked like good numbers for a min tool length based on the tool and holder used for this roughing routine.