A nice YouTube video

[gcode]

">

[Dan_AKA_ROY23]

:_thumbup:

[byte]

Is this a common feature to make gcode?

[mayday]

I would have created surfaces, untrim and extend off the solid for entry exit, much easier to control

[byte]

I would have created surfaces, untrim and extend off the solid for entry exit, much easier to control

Still with parallel?

[gcode]

I would have created surfaces, untrim and extend off the solid for entry exit, much easier to control

I think they are chasing Fusion360.
The goal being zero or minimal geometry creation to drive toolpaths.

Mastercam is getting much better at using solids and I've been using solids more and more
for drive geometry, but most of the time you can still get a better toolpath building surface
drive geometry

[byte]

I would have created surfaces, untrim and extend off the solid for entry exit, much easier to control

I think they are chasing Fusion360.
The goal being zero or minimal geometry creation to drive toolpaths.

Mastercam is getting much better at using solids and I've been using solids more and more
for drive geometry, but most of the time you can still get a better toolpath building surface
drive geometry

They need to fix the issue with importing/exporting toolpaths with solids..

[mayday]

never liked driving solids if I have to do something crazy to limiting. I'll probably have a seat of Esprit along with MC might be best for the mill turn stuff

[Rstewart]

Having not much multi Ax experience, can you do that path in multiple depth cuts?  Basically rough it with depths.

[mayday]

yes depth cut options are available