Cimco Verify for Mastercam

[CNCAppsJames]

I moaned like fook at them when X7 and the new UVB was introduced - round holes all faceted etc... it was shite compared to the previous legacy X6 verify.
Time to go fullll circle

Well, when companies make bad hiring decisions in product development or poor promotion choices that's kinda what almost always happens.

Mastercam V6 (not X6) had a C-Hook called SyncLathe (IIRC)... the frame work was there for improvement for multi-tasking environments. The problem; certain individuals didn't understand it and didn't create it therefore it should be abandoned.

People in positions of power and fake influence spend far too much time and capital (both monetary and leadership) putting their fingerprints on stuff because their fragile egos can't handle other people's good ideas. It's sad and pathetic really.