Does cycle time matter when running more than one machine?

Started by champshire, October 05, 2026, 09:40 AM

Previous topic - Next topic

0 Members and 1 Guest are viewing this topic.

Go Down Pages 1 2

Newbeeee™

#15
October 07, 2026, 06:33 AM
Quote from: CNCAppsJames on October 07, 2026, 06:01 AMSo the extra numbers are for poor planning.

✅️

:coffee:

:rofl:
AND shite machining :hrhr:
Like Like x 1 Funny Funny x 1 View List
TheeCircle™ (EuroPeon Division)
     :cheers:    :cheers:

champshire

#16
October 07, 2026, 11:51 AM
You are both correct!
Funny Funny x 1 View List

megatronprime

#17
November 01, 2026, 03:48 PM
Quote from: champshire on October 05, 2026, 09:40 AMCurious to the consensus here. If a person is running more than one op in a cell, does cycle time matter? For example, Op 10 takes one hour. Op 20 takes 1.5 hrs. Does it make sense to take any time out of OP 10?

My vote is yes, always try and make everything as fast as possible.
Only if finishing all the OP 10 early allows you to do start another job earlier
Go Up Pages 1 2