The Assimilation Continues

[CNCAppsJames]

Yea looks like my local MLC guys are not affiliated with Mastercam anymore. Too bad, they were really responsive and good to work with. I have not had the same experience with the Mothership.

Attention Mothership. Prove me wrong, please.

As of a couple weeks ago Patrick still was... I'll see him tomorrow. 

[CNCAppsJames]

So, I wonder when eMastercam is going to get shut down? I'd imagine it's only a matter of time.

Mastercam's forum could contain as much good info as eMastercam... in 20 years.

 

[neurosis]

So, I wonder when eMastercam is going to get shut down? I'd imagine it's only a matter of time.

Mastercam's forum could contain as much good info as eMastercam... in 20 years.

Does anyone know if the plan is to leave these places to continue running as they had in the past or is this going to be an absorbing of these large resellers?

[Newbeeee™]

Mastercam's forum could contain as much good info as eMastercam... in 20 years.

You sure about that Willis?
Granted.... last time I logged in at Ivory Central would have been prolly 2018, but it was deadder than a Dodo on dead Dodo day.
So unless there's been an influx of mucho posting regarding materials, methodology, machine purchasing choices, control options, fault finding, CAD software help and model creation, CAM programming, Post processor modifications etc, with valid input from the people with "the right stuff", I canny see shit captain!

[Newbeeee™]

Does anyone know if the plan is to leave these places to continue running as they had in the past or is this going to be an absorbing of these large resellers?

My 10bucks of experience with BigCorp, is the new cheeses usually don't doo detail - "out with the old" etc....