Drill cycle

[CADCAM396]

in need of a modification to my Fagor post drill cycle. am clueless on posts so be gentle.

I need 98 G81 Z.1 I-.25 F30. (the i is drill depth for fagor what a freak)

current post code is

pdrill$          #Canned Drill Cycle
    
      pdrlcommonb
     pcan1, pbld, n$, *sgdrlref, *sgdrill, pdrlxy, prdrlout, pcout,
          "I",no_spc$, PFZOUT, [if dwell$, *dwell$], *feed, strcantext, e$
      #pcan1, pbld, n$, *sgdrlref,"CHANGE Z TO I" *sgdrill, pdrlxy, pZout, pcout, pindexdrl,
       # prdrlout, [if dwell$, *dwell$], *feed, strcantext, e$
      #pcom_movea

outputs this G98 G81 Z.1 IZ-.25 F30.    need that Z to go away.

TIA   Doug

[JParis]

Remove the

pzout

That'll remove the Z output