XOMETRY - Anyone used these guys?

[neurosis]

Anyone used this company? 

The boss has been looking in to them and want's to know if anyone has any experience with them.

[riverhunter]

I used them for a short time.  Turn around is usually 3-5 days.  decent work and fair price.  drawings are not too fussy.  at then end of the day, there are better ways to get work in my opinion. 

[JakeL]

Can't remember where I read it, but IIRC someone was recently talking about how the quality of their work has gone downhill. I don't have any personal experience, but if I find the original source I'll link it.

[Zoffen]

Are you looking to buy parts or make parts for them?

[neurosis]

Are you looking to buy parts or make parts for them?

I think he's looking to do a little of both. 

We have a batch of parts that he doesn't want to make and there are around 2000 of them. 

I think he plans on grabbing some work off of there while Boeing is on strike but I'm not 100% sure about that at this point.

[CNCAppsJames]

I just met a customer that uses them... he ONLY takes the hard parts. He says he does well. He's got 5-Axis machines, skilled machinists amd programmers. 

It's definitely not fir everyone.  

[JakeL]

Can't remember where I read it, but IIRC someone was recently talking about how the quality of their work has gone downhill. I don't have any personal experience, but if I find the original source I'll link it.

Finally stumbled across the original source again:
Practical Machinist Link