Is the tech exchange dead on Mastercam.com

[Newbeeee™]

I wish I had a clue what you are talking about

You think that's a lot to grasp....try listening to @Thee Byte and try keeping up with what he's up to....

[kdg]

There's a new response on the official forum, corp-speak for this is now a new revenue stream.
I look forward to a more positive experience now, lol.
"Director, Customer Success", LOL.

During the review of the Tech Exchange in 2025 we uncovered many legacy post processors that were not current which would provide a negative customer experience. We would encourage your local Mastercam representative to provide you with a dedicated solution for the exact machine make, model and controller post processor which will then be fully supported and maintained for future releases of Mastercam, delivering a positive experience.

Lee Richards / Director, Customer Success

[Here's Johnny!]

During the review of the Tech Exchange in 2025 we uncovered many legacy post processors that were not current which would provide a negative customer experience. We would encourage your local Mastercam representative to provide you with a dedicated solution for the exact machine make, model and controller post processor which will then be fully supported and maintained for future releases of Mastercam, delivering a positive experience.

Pay up!!! 

[TSmcam]

We would encourage your local Mastercam representative to provide you with a dedicated solution bloated quote for the exact machine make, model and controller post processor which will then be fully supported and maintained for future releases of Mastercam, delivering a positive experience.

Sad to think that they used to provide top quality posts foc, that were easily customisable. Are the MPMaster and MPLMaster posts still available? (Not that it matters to me nowadays) I built many customer posts back in the day from those great foundations.

[gms1]

Are the MPMaster and MPLMaster posts still available? (Not that it matters to me nowadays) I built many customer posts back in the day from those great foundations.

Those are about it for posts now. I did manage to get the base haas y axis post from my reseller (yes i still have a reseller) after a few days. I am just gonna have to start building from my old posts now.

[MIL-TFP-41]

And don't forget, along with having to buy a post there will be a yearly maintenance charge for the post. IMO, one of Mastercam's strengths historically was being able to customize a post to your liking. If they are now charging for posts, I have no doubt that some of the good stuff will be binned away, a mere user will not have access.

It really makes me want to dive into the AI post processor.