ARRRRRGH!!!!

[Incogneeto]

What should I do this afternoon?

Find a Welder??

[Del.]

Find a Welder??

Last job I was at I asked a guy if there were any parts that didn't have weld on them. He said if there weren't then we haven't touched them yet.

[Incogneeto]

Last job I was at I asked a guy if there were any parts that didn't have weld on them. He said if there weren't then we haven't touched them yet.

HAHHHAAAAAAAAAAAAAAA

[gcode]

Find a Welder??

Normally in a situation like this we would turn the bad diameter .50" undersized
freeze fit and weld an oversized ring on it and remachine it.
In this case, I don't think there is room.
We've submitted it to the customer. Now, it's wait and see what they say.

[mowens]

True, but you were doing a piss poor job of driving that chair.
Chairs don't just fall over by themselves. 

I swear ociffer, i was tryin to keep that chair from committing suicide!

No, G, you're right. My daughter called and asked for my wife, who was in another room. I scooted the chair so I had a better angle to talk to my wife and that damn chair just jumped!

[Incogneeto]

Normally in a situation like this we would turn the bad diameter .50" undersized
freeze fit and weld an oversized ring on it and remachine it.
In this case, I don't think there is room.
We've submitted it to the customer. Now, it's wait and see what they say.

That is Lucky. Still a lot of work and you have to eat it, But better than a total loss.

They still gonna eat you up on behind time.

Your new manager is gonna learn fast. (Ouch)

[Incogneeto]

I swear ociffer, i was tryin to keep that chair from committing suicide!

No, G, you're right. My daughter called and asked for my wife, who was in another room. I scooted the chair so I had a better angle to talk to my wife and that damn chair just jumped!

"Women are the root of All Evil"

[Flycut]

Well that makes my biggest fuck up seem insignificant.
Hate to be in the lathe guys shoes.

[CNCAppsJames]

Quicker than that
film the first pass and quick shot of the finished part and roll the credits.
I'm a freakin' machining genius. BOOM!!!
That was my morning well spent.
What should I do this afternoon?

Teach guys how to deburr...

[gcode]

Teach guys how to deburr..

the lathe guy was required to fill out a cause and corrective action report

the cause... a burr caused an incorrect measurement resulting in a bad offset adjustment for the finish pass

the corrective action .... reprogram the semifinish pass so there is no burr 

[RobertELee]

the lathe guy was required to fill out a cause and corrective action report

the cause... a burr caused an incorrect measurement resulting in a bad offset adjustment for the finish pass

the corrective action .... reprogram the semifinish pass so there is no burr 

Remember, it's never the operators fault 

[Incogneeto]

Remember, it's never the operators fault 

6 Points.

[Elmer Fudd]

Teach guys how to deburr...

Calling Incogneto

[Incogneeto]

Calling Incogneto

Bout damn Time!!!

I Can Fix That!!

[RobertELee]

Calling Incogneto

Hard to teach someone how when you're still in the learning stages as well.